Attenuators: Difference between revisions
Jump to navigation
Jump to search
(removed table code - added resistor tables as jpg's) |
|||
| Line 11: | Line 11: | ||
* To produce low power for [[QRP | QRP]] transmissions. many modern HF rigs have a minimum power out of around 5 Watts. QRP operators usually use powers well below this. | * To produce low power for [[QRP | QRP]] transmissions. many modern HF rigs have a minimum power out of around 5 Watts. QRP operators usually use powers well below this. | ||
=Attenuator Circuits = | ==Attenuator Circuits == | ||
==The pi circuit== | ===The pi circuit=== | ||
In the circuit below, known as a pi pad; | In the circuit below, known as a pi pad; | ||
| Line 25: | Line 25: | ||
Approximate resistor values for a single pi pad are as follows | Approximate resistor values for a single pi pad are as follows | ||
[[Image:Pi_pad.jpg | 300px]] | |||
== The T circuit == | |||
=== The T circuit === | |||
In the circuit below, known as a T pad; | In the circuit below, known as a T pad; | ||
| Line 50: | Line 40: | ||
Approximate resistor values for a single T pad are as follows | Approximate resistor values for a single T pad are as follows | ||
[[Image:t_pad.jpg | 300px]] | |||
= How is attenuation measured?= | == How is attenuation measured?== | ||
Attenuation is measured in decibels (dB) of relative power. A guide to the attenuation-dB relationship is: | Attenuation is measured in decibels (dB) of relative power. A guide to the attenuation-dB relationship is: | ||
Revision as of 20:49, 25 December 2008
Related wiki pages; Apparatus, Dummy Load
What is an attenuator?
An attenuator is a resistive device that reduces the amplitude of a signal without adding distortion to it. The amplitude of a radio signal is the power, so an attenuator is used to reduce the power of a transmission.
When would we use one?
- When making transmission measurements using highly sensitive equipment. The attenuator reduces power to protect the measuring equipment.
- To produce low power for QRP transmissions. many modern HF rigs have a minimum power out of around 5 Watts. QRP operators usually use powers well below this.
Attenuator Circuits
The pi circuit
In the circuit below, known as a pi pad;
- RA = Arm resistor
- <math>RL_1</math> = leg resistor 1
- <math>RL_2</math> = leg resistor 2
Approximate resistor values for a single pi pad are as follows
The T circuit
In the circuit below, known as a T pad;
- RL = Leg resistor
- <math>RA_1</math> = Arm resistor 1
- <math>RA_2</math> = Arm resistor 2
Approximate resistor values for a single T pad are as follows
How is attenuation measured?
Attenuation is measured in decibels (dB) of relative power. A guide to the attenuation-dB relationship is:
| dB | Attenuation | Power in | Power out |
| 3dB | 0.5 | 100W | 50W |
| 6dB | 0.25 | 100W | 25W |
| 10dB | 0.1 | 100W | 10W |
| 20dB | 0.01 | 100W | 1W |
| 30dB | 0.001 | 100W | 0.1W |