SWR

Related wiki pages Antennas, Gain, Propagation, Bands, harmonics, Front-to-back ratio

Standing Wave Ratio - (SWR)

What is SWR?

When there is a mismatch between the output impedance of a transmitter and input impedance of an antenna, some of the signal - in the form of a wave - is reflected back down the transmission line to the transmitter. Standing waved of electrical energy will "appear" in the transmission line. SWR is the ratio:

Amplitude (height) of the standing wave : Amplitude of an adjacent node (central point on the wave form)

The most commonly used SWR measurement is Voltage SWR or VSWR. Current SWR or IVSWR is rarely used but provides the same information. The diagram above can be thought of as representing either voltage or current.

If the feedline has no loss, and has the same impedance as the transmitter output and the antenna input impedance, then maximum power will be delivered to the antenna. In this case the VSWR will be 1:1 and the voltage and current will be constant over the whole length of the feedline.

How is SWR related to forward and reflected power?

The proportion of power to the antenna that is reflected back down the feedline is known as reflected power. It is determined by the reflection coefficient <math> \rho </math> at the antenna, given by:

<math> \rho = \frac{Z_1 - Z_0} {Z_1 +Z_0} = \frac {E_r}{E_f} </math>

where:

<math> Z_1 = </math> antenna impedance

<math> Z_0 = </math> feedline impedance

<math> E_f = </math> forward voltage - towards the antenna

<math> E_r = </math> reflected voltage

<math> VSWR = \frac {1+ \sqrt (\frac{P_r}{P_f})}{ 1- \sqrt(\frac{P_r}{(P_f})} </math>

where:

<math> P_r = </math> reflected power

<math> P_f = </math> forward power - towards the antenna

Some myths about SWR

1) I can calculate SWR to a ratio of 1.000 : 1

Most instruments do not operate that this level of accuracy

2) High SWR is bad

Look here for very detailed discussion about SWR

3) My SWR meter is the best on the market so is infallible

Any instrument that is placed between the transmitter and the antenna changes the characteristics of the transmission line.

4) High SWR will interfere with my neighbours TV

Your transmissions are most likely to interfere with other services when:

• your transmitter puts out a broad band signal rather than a narrow band signal
• the TV station that your neighbour is watching is on a frequency that is a harmonic of your TX frequency
• you are using high power into a beam that is at the same height and directed towards your neighbours TV antenna

How is SWR calculated?

Briefly, use an SWR meter, but better still - see the above discussion about SWR calculations until someone puts more information in this section or look at the following links:

Online SWR calculator from VE3KL

Antennas
Design	Beam * Dipole * Dish or Parabola * DDRR * Log Periodic (LPDA) * Loop * Mobile and portable * Omnidirectional * Panel * Quad and Quagi * Screwdriver * Small tuned loop * Vertical * Yagi-Uda * Wire and random wire antennas
Installation	Antenna Tuners * Capacity hats and loading coils * Cavity filters * Coaxial Cable * Feedlines * Rotators * Towers and Masts * VK2ACY - G5RV coupler
Theory	Front-to-back ratio * Impedance matching * SWR * Tower design * Vertical Antenna efficiency * Wire comparison tables